JK front axle TRUSS
heavy duty and light weight truss system and armor is designed to take
serious abuse and reinforce your front 30 or 44 JK axle. The 1/4" thick
truss top and 10Ga. gusseting incorporates a unique design to strengthen
both axle tubes, not just the long tube (commonly found in "other"
designs). The precision cut and formed components of this setup ensure a
1/4" and 10 gauge (.130") mild steel. Precision CNC cut and bent for great fitment.*
Truss is low profile to allow clearance above the axle.
Truss spans length of long side AND short side.
Truss is reinforced using interlocked 10 gauge thick gussets for maximum strength and easy assembly.
low profile design means your axle is stronger, sleeker, easier to fit
into any vehicle, and less likely to interfere with vehicle components.
KIT IS INTENDED FOR VEHICLES WITH AT LEAST MINOR LIFTS. IF USING WITH
NO LIFT, CHECK CLEARANCES BEFORE INSTALLING. NOT TESTED IN NON-US JKs
WITH DIESEL ENGINES or RIGHT HAND DRIVE AXLES.**
This kit requires general welding and fabrication skills including
welding to the cast center section. Welding should only be done by a
competent welder. Artec Industries implies no guarantees or warranties
and is not liable for improper installation.
grinding and fitment may be required when installing this kit. Every
axle varies slightly and some fabrication may be required.
In rare and extreme cases, the truss may come into contact with oil
pan. Prior to operating the vehicle, remove the coil springs, cycle the
suspension including full compression of both sides simultaneously and
add bumpstop extensions to prevent damage to oil pan.